Cleaning And Maintenance - Utilitech NT15-20A Manual Del Usuario

Safety Feature
1. Thermal cut-off: This heater includes a thermal cut-off that shuts the heater off if
it overheats due to abnormal conditions. If this occurs, turn the heater off, unplug
it, inspect and remove any objects on or adjacent to the heater. Allow it to cool for
a few minutes, and then plug it back in and resume normal operation.This is not a
defect!
2. Tip over switch: This heater includes a safety tip over switch, which will shut the
heater off in case it is tipped over. If at any time, the heater does tip over, please
place the heater back in the upright position. The heater will resume its normal
operation.
Reset Instrictions
If the unit shuts down please operate as follows:
1. Turn the unit off
2. Unplug unit wait 10 minutes
3. Plug in and turn on
If Your Heater Fails To Operate
1. Be sure it is plugged in and that the electrical outlet is working.
2. Check for any obstruction. If you find an obstruction turn the heater OFF.Unplug
the heater and wait at least ten minutes for it to cool. Carefully remove the
obstruction. Plug the heater back in and restart it as described under
OPERATION.
3. If the unit is operating the same as mentioned above, remove the plug from the
socket and have appliance serviced by authorized electrician only.

CLEANING AND MAINTENANCE

We recommend that the heater be cleaned at least once a month and before
off-season storage.
1. Turn the heater OFF and unplug it. Allow it to cool.
2. Use a dry cloth to clean the external surfaces of the heater.
DO NOT USE WATER, WAX, POLISH OR ANY CHEMICAL SOLUTION.
1. Clean your heater using the above-mentioned steps, then pack the heater in its
original container and store in a cool dry place.
2. This heater does not disassemble.
3. The motor is factory lubricated for life, and will require no further lubrication.
7