Application Examples - Kathrein EXR 504 Manual De Instrucciones

General
Only the power unit NCF 18 may be used in order to comply with the EMC requirements
Unoccupied subscriber outputs must be terminated with 75 Ω termination resistors EMK 03
Max. ambient temperature: -20 to +55 °C
RF and DC connections: F-connectors
Accessories (in the scope of delivery):
EXR 504: Power unit NCF 18
Settings of the satelitte receiver
!
For optimal control of the series 500 switching matrices 500 series, you can effect the following
settings in the menu setting of your satellite receiver*):
Achtung Attention
Setting
DiSEqC off
22 kHz –– > High/Low
22 kHz –– > Pos A/B
LNB voltage supply in stand-by mode set to off
*) Terms from the setting menu of other manufacturer's satellite receivers can deviate from above terms
Electronic equipment is not household waste – in accordance with directive 2002/96/EC OF THE EUROPEAN PARLIAMENT AND
THE COUNCIL of 27th January 2003 on used electrical and electronic equipment, it must be disposed of properly.
At the end of its service life, take this unit for disposal at a relevant official collection point.

Application examples

Sat IF 950-1950 MHz anlogue
Sat IF 1100-2150 MHz digital
Minimal level at input of
EXR 504:
Sat 75 dBµV
VHF 80 dBµV
UHF 90 dBµV
Maximal cable length 75 m
Terrestrial
antenna
Effect
Switch-over time of the receiver is reduced
For analogue and digital selection of a satellite
For selection of 2 satellites (Multifeed)
Power saving