Worx WX283 Manual Original página 11

2. ON / OFF SWITCH (See Fig. C)
Depress the On/Off switch (5) to start and
release it to stop your tool. The on/off switch is
fitted with a brake function which stops your
chuck immediately when you quickly release
the switch.
It is also a variable speed switch that delivers
higher speed and torque with increased
trigger pressure. Speed is controlled by the
amount of switch trigger depression.
WARNING: Do not operate for
long periods at low speed because
excess heat will be produced internally.
3. SWITCH LOCK
The switch trigger can be locked in the OFF
position. This helps to reduce the possibility of
accidental starting when not in use. To lock the
switch trigger, place the rotation control in the
center position.
4. REVERSIBLE (See Fig. C)
For drilling and screw driving use forward
rotation marked "
left). Only use reverse rotation marked "
(lever is moved to the right) to remove screws
or release a jammed drill bit.
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
5. CHUCK ADJUSTMENT (See Fig. D)
Detachable chuck is suggested for using in the
drill mode.
To open the chuck jaws, firmly hold the rear
sleeve of the chuck, and then rotate the
front sleeve. Insert the drill bit between the
chuck jaws and rotate the front sleeve in the
opposite direction. Ensure the drill bit is in the
center of the chuck jaws. Finally, hold the rear
sleeve of the chuck and firmly rotate the front
sleeve in the opposite directions. Your drill bit
is now clamped in the chuck.
6. USING THE LED LIGHT
To turn on the light simply press the on/off
switch. When you release the on/off switch,
the light will be off.
LED lighting increases visibility-great for
3 in1 drill/driver/impact driver
" (lever is moved to the
dark or enclosed area. LED is also a battery
capacity indicator. It will flash when power
gets low.
7. FUNCTION MODE SELECTION
The operation of the tool for each application
is set with the function mode selection switch
(9). To change between functions, slide the
function mode selection switch (9) to the
desired operating mode as follows:
Screwdriver mode (See Fig. E1)
Drill driver mode (See Fig. E2)
Impact driver mode (See Fig. E3)
WARNING: When using the function
mode selection switch, use only when
the tool stops. But when the switch does not
easily move, depress the On/off switch slightly
to rotate the spindle and then move the
function mode selection switch.
"
SCREWDRIVING OPERATION
Slide the function mode selection switch (9) to
mark" " . Adjust the adjusting ring (8) to the
proper torque level for your work.
The torque is adjusted by rotating the torque
adjustment ring (See Fig. F). The torque is
greater when the torque adjustment ring is set
on a higher setting. The torque is less when
the torque adjustment ring is set on a lower
setting.
Make the setting as follows:
1 - 4 For driving small screws
For driving screws into soft mate-
5 - 9
rial
For driving screws into soft and
10 - 14
hard material
15 - 19 For driving screws into hard wood
20 - 22 For driving larger screws
DRILLING OPERATION
Slide the function mode selection switch (9)
to mark
11
EN