REMOVE TAPE LINERS FROM THE TAPE DIE-CUTS, SHOWN BELOW (2X PER SIDE).
PEEL BACK APPROXIMATELY 2.0" (50mm) OF TAPE LINER (3X PER SIDE).
FOLD TAPE LINER ONTO THE SPOILER SURFACE AND SECURE WITH MASKING TAPE.
11
INSTALL THE REAR SPOILER (ITEM A) ONTO THE TRUNK LID. MAKE SURE TO LINE UP THE STUDS WITH THE HOLES
AND THE GREASE PENCIL MARK FROM STEP #10.
12
USING THE PULL TABS, REMOVE TAPE LINERS.
13
05/03/2013
CONFIRM THE SPOILERS ALIGNMENT BEFORE
PUSHING DOWN AND ENGAGING
THE DOUBLE SIDED TAPE.
USING HAND PRESSURE, START FROM THE CENTER
AND WORK OUTWARDS, APPLY 15lbs OF PRESSURE
FOR 30 SECONDS OVER THE ENTIRE TAPE AREA.
14
EN-
Page 5 of 6
2.0" (50mm)
K6861589
