USING THE ALCOHOL WIPE (ITEM D), CLEAN AREA WHERE THE SPOILER IS TO BE INSTALLED.
8
DE-BURR ALL HOLES DRILLED IN THE SHEET METAL. TREAT ALL DRILLED LOCATIONS WITH CORROSION
INHIBITOR. THIS INCLUDES HOLES IN BOTH THE INNER AND OUTER SHEET METAL.
OUTER
9
TEST FIT SPOILER (ITEM A) ONTO TRUNK LID. CONFIRM THE SPOILER STUDS FIT INTO THE HOLES AND THAT
THE SPOILER IS CENTERED ON THE TRUNK LID.
USE A GREASE PENCIL TO MARK A LINE THAT WILL BE USED AS REFERENCE IN STEP #12.
10
05/03/2013
ADJUST IF NECESSARY AND REPEAT STEPS #8 & #9.
EN-
Page 4 of 6
INNER
K6861589
