OPEN TRUNK LID AND PLACE A DROP CLOTH INTO REAR LUGGAGE AREA
DIRECTLY UNDERNEATH THE TRUNK LID.
1
USING A GREASE PENCIL, MARK A LINE AROUND THE
EDGE OF THE TRUNK LID'S INNER LINER. THIS LINE IS
TO BE USED AS REFERENCE IN STEP 7.
2
CUT OUT AND SECURE OUTER SHEET METAL DRILL TEMPLATE (ITEM B) ONTO THE REAR TRUNK LID USING
MASKING TAPE. MAKE SURE THE TEMPLATE IS CENTERED ON THE TRUNK LID BEFORE CENTER PUNCHING
5X HOLE LOCATIONS.
CENTER PUNCH
5X HOLE
LOCATIONS
4
05/03/2013
REMOVE TRUNK LID INNER LINER.
3
CONFIRM ALIGNMENT OF THE TEMPLATE BEFORE
CENTER PUNCHING THE HOLE LOCATIONS
EN-
Page 2 of 6
10x
K6861589
