Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Notes on Microphone System Operation
• In a system using eleven or fewer microphones, maintain
a distance of at least 30 cm (1 ft) between each pair of
microphones, and a distance of at least 3 m (10 ft)
between each microphone and its receiving antenna. If
using the microphone with WRT-810A/820A units in a
system with 12 to 19 channels, maintain a distance of at
least 6 m (20 ft) between each microphone and its
receiving antenna.
For details of operation with two or more channels, refer
to the Operating Instructions for the WRR-810A UHF
Synthesized Tuner and the WRR-820A/840A/860A UHF
Synthesized Diversity Tuner.
• Ensure that the tuners set to channels not being used are
either turned off or set to the minimum output level (the
LEVEL adjustment knob set to MIN).
• When powering the microphone on or off, to keep the
noise to a minimum, set the audio output level from the
tuner or mixer to a minimum.
• Powering the microphone on without checking the
channel selection first may interfere with the operation of
other microphones/transmitters, if the current setting is
already being used.
Changing the Input Attenuation
Select an attenuation of 0, 6 or 12 dB according to the input
sound level.
0
-6
-12
Error Codes
In addition to the normal channel indication, the following
error codes may appear in the LCD window.
Error codes
Error code
Meaning
An error occurred in
Err 1
the data in backup
memory.
Err 2
A fault occurred in
the PLL synthesizer
circuit.
Battery voltage
Err 3
exceeds the
specified limit.
Attenuator switch
Required action
The data is
reinitialized. Reinsert
the battery, and set
the channel again.
Consult your Sony
dealer.
Use the correct
battery.
11
Capítulos
Tabla de contenido
