AIRFORCE F139 A Montaje Y Modo De Empleo página 46

Use
The cooker hood is provided with an upper air exit B for
discharging fumes externally for models including chimney flue
C ( Suction Version A- exhaust pipe not supplied).
If cooking fumes and vapours cannot be externally discharged,
the cooker hood can be used in the recirculating version F:
the installation of 1 active charcoal filter F allows the recirculation
of fumes and vapours through the upper grid G.
WARNING (F139F): The charcoal filters supplied in the carton
must be installed before the use of the cooker hood.
Operation
4
1: + motor
2: On/Off motor
3: - motor
4: On/Off light
5: Led
(139 A)Note: the LED on the hood indicates the various
st
speeds: green 1 speed, orange 2
th
flashing red 4 speed.
„If the remote control unit is changed, the appliance must be
reset to the frequency of the new unit as follows:
1. Disconnect the power supply to the hood.
2. Wait 5 seconds and then switch the power
supply on again.
3. Within the first 5 seconds, press the button for the
lights and release it when the lights come on.
4. Within 5 seconds, press and release the motor
button.
You will then need to wait for about 10 seconds, after
which the hood can be used as normal. Whenever the
power supply is disconnected, you must wait for 10
seconds before using the extractor."
USER INSTRUCTIONS
5
1
2
3
nd rd
speed, red 3 speed and
Maintenance
Prior to any maintenance operation ensure that the cooker hood
is disconnected from the electrical outlet.
C l e a n i n g
The hood must be cleaned frequently both inside (apart from
the area behind the grease filter) and outside. Use a cloth
moistened with denatured alcohol or neutral liquid detergents.
Never use products containing abrasives.
Warning: Failure to carry out the basic standards of the
cleaning of the cooker hood and replacement of the filters may
cause fire risks. Therefore we recommend observing these
instructions.
Anti-grease Filter:
must be cleaned once a month, with non abrasive detergents,
by hand or in dishwasher on low temperature and short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
Charcoal Filter - (only for filter version)
Carbon filters can be regenerated only once by washing at
low temperature in a dishwasher, then drying in an ordinary
kitchen oven at 90ºC for approx. 10 minutes.
Each filter must be regenerated or replaced as soon as the
respective warning indicator on the hood lights up.
For hoods without filter replacement warning indicators, we
recommend washing / replacement approximately every
six months assuming the hood and cooker are in normal
use.
Replacing lightbulbs
Warning! Prior to touching the light bulbs ensure they are cooled
d o w n .
Open the light cover by pressing with a finger the part marked
„ p u s h " .
Replace the dead bulb.
Use only a halogen bulb of 20W max (G4), taking care not to
touch it with naked hands.
Close the light cover.
Extract the lamp cover by levering it off with a small screwdriver
or similar tool.
Replace the damaged light bulb. Only use halogen bulbs of 20W
max (G4), making sure you do not touch them with your hands.
Close the lamp cover (it will snap shut).
Led Light
If the lighting group LED does not work, please contact the
technical service center in order to replace the whole group
Declaration of Conformity:
We, Airforce S.p.A. via Ca' Maiano 140/E 60044 Fabriano AN
ITALY, declare that the models:
- F139 A;
- F139 F;
to which this declaration refers conform to the following European
directives with the amendments and national legislation
implementing these directives:
-EMC 2004/108/EC;
-LVD 2006/95/EC.
For further technical information or contact details, please turn
to the last page of the manual.