Advancing The Line; Adjusting The Handle Height; Advancing The Line Manually - Toro Power Plex 51130 Manual Del Usuario

Advancing the Line

Note:
The trimmer is equipped with an auto-feed
head.
1. With the trimmer running, release the switch
trigger.
2. Wait a few seconds, then press the lockout
button and squeeze the trigger.
Note:
The line extends approximately 6 mm
(1/4 inch) with each stop and start of the trimmer
until the line reaches the length of the grass
deflector blade.
3. Resume trimming.
Advancing the Line
Manually
Remove the battery from the trimmer, then push the
button at the base of the spool retainer while pulling
on the trimmer line to manually advance the line.
Figure 12
1. Button
Adjusting the Handle
Height
1. Loosen the lower shaft connector (A of
13).
2. Slide the telescoping shaft to your desired
position (B of
Important:
over the vents on the lower shaft and do not
remove the rubber bumper.
3. Tighten the handle connector to secure the
handle (C of
g203810
13
Figure 13).
Do not slide the upper shaft
Figure 13).
Figure 13
Figure
g189876