Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Adjusting The Trimming Line
Length
Your trimmer is equipped with a bump head that
allows the operator to release more trimming line
without stopping the motor. To release additional line,
lightly tap the trimming head on the ground (Fig. 9)
while operating the trimmer at high speed.
Note:
Always keep the trimming line fully
extended. Line release becomes more
difficult as cutting line becomes
shorter.
Each time the head is bumped, about 1 inch
(25.4 mm) of trimming line is released. A blade in the
string guard will cut the line to the proper length if
excess line is released.
For best results, tap the head on bare ground or hard
soil. If line release is attempted in tall grass, the
motor may stall.
Decorative Trimming
Decorative trimming is accomplished by removing all
vegetation around trees, posts, fences, etc.
(Fig. 10).
EN–7
Maintenance
POTENTIAL HAZARD
When extension cord is plugged into an
outlet and connected to trimmer, trimmer is
operational. Someone could accidentally
start the trimmer.
WHAT CAN HAPPEN
Accidental starting of trimmer could
seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
Always unplug your trimmer before you
clean or perform any maintenance on it.
Line Installation
The trimming line may be replaced by two different
methods — rewinding the existing reel or installing a
prewound reel.
Rewinding The Existing Reel
To rewind the existing reel you must:
1.
Check for the correct line size.
2.
Remove the existing reel and spring.
3.
Wind the existing reel with the new line.
4.
Reinstall the existing reel and spring.
Capítulos
Tabla de contenido
