sanindusa PLAN Instrucciones De Montage Y Manutencion página 44

//INSTALLATION
3 4
3 – Connect the wire from the electronic unit onto the cover plate to the
solenoid's connector.
4 – Connect the other wire from the electronic unit to the power source
connector.
5 – Assemble the panel to the cover seat and tighten it with the bottom
screw.
6 – Remove now the protecting sticker that covers the sensor.
5
7 – For transformer model, plug the transformer.
Important: After connecting the power source, wait a few seconds before
activating the flush valve to avoid entering into "adjusting mode".
8 – Move away and the flush valve will flush a few seconds after your
departure.
9 – If needed adjust the flow capacity by turning the regulating valve.
10 – If the range is unsatisfactory, refer to the section entitled "Settings
Adjustment".
6
44//45