Maintenance And Storage - FLORABEST FLS 3000 B2 Traducción Del Manual De Instrucciones Original

GB IE
- when you are carrying out
cleaning or maintenance work
or replacing accessories;
- when the power or extension
cable is damaged; after con-
tact with foreign bodies or in
case of abnormal vibration;
• Do not vacuum any moist or
wet material or any liquids.
• Do not use the device in closed
or badly ventilated rooms. Do
not use the device near inflam-
mable liquids or gases. In case
of non-observance of these
directions, danger of fire or ex-
plosion exists.
• If an accident or fault occurs
during operation, immediately
switch off the device and dis-
connect at the plug. For the cor-
rection of faults, read the "Trou-
bleshooting" chapter or contact
our Service-Centre.
• Walk at a steady pace, do not run.
• Make sure that the mains volt-
age is compatible with the infor-
mation of the label.
• Keep the cable away from the
field of action and basically
play it out behind the operator.
• Do not carry the device by the
cable. Do not use the cable to
pull out the plug from the plug
socket. Protect the cable against
heat, oil and sharp edges.
• Damaged cables, coupling and
plugs or connecting leads not
corresponding to specifications,
must not be employed. Remove
the plug immediately from the
plug socket in case of dam-
age to the mains cable. Do not
touch the mains power supply
cable under any circumstances
28
until you have pulled the plug
out of the mains socket.

Maintenance and storage:

• Check the operational service-
ability and integrity of the de-
vice regularly in order to avoid
danger to the operator.
• Only use the replacement parts
that are supplied and recom-
mended by our Service Centre.
• Do not attempt to repair the
appliance yourself unless you
have specific training to do so.
Leave any work not listed in this
manual to our Service Centre.
• Keep the device in a dry loca-
tion and out of reach of children.
• Handle the unit with care.
Clean the ventilation slits regu-
larly; keep to the maintenance
instructions.
• Keep all cooling air inlets clear
of dirt.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not use the appliance if the
on/off switch does not work
properly. Always have a dam-
aged switch repaired by our
Service Centre.
• Do not overload your device.
Work only within the indicated
range of performance. Do not
employ any low power ma-
chines for heavy work. Do not
use your device for purposes for
which it has not been designed.