Reversing Doors
1. Complete steps 1-2 in "Removing Handles"
section and steps 1-12 in "Removing Doors"
section.
2. Remove cover on handle nameplate by lifting
end. Bend tabs behind nameplate up and
remove nameplate. Rotate nameplate one half
turn. Replace nameplate and cover.
3. Remove plastic plugs from side of doors. Insert
in opposite side.
4. Place door handles on Fresh Food and freezer doors.
Fresh Food handle becomes freezer handle and
freezer handle becomes Fresh Food handle. Insert
screws and tighten.
5. Replace door handle screw caps by snapping in.
6. Remove door stops from side of doors by removing
screws. Replace door stops on opposite side.
7. Place bottom hinge and spacer(s) on opposite
side of refrigerator cabinet. Insert screws and
tighten.
Important:
Spacer ring(s) can be moved to properly adjust doors.
8. Move bottom hinge pin to opposite hex hole.
Place spacer ring(s) on hinge pin.
9. Remove plastic plugs from side of refrigerator
cabinet. Insert in opposite side.
10. Turn over center hinge bracket and spacer(s).
Place bracket and spacer(s) on opposite side of
refrigerator cabinet. Insert screws and tighten.
11. Rehang Fresh Food door by positioning bottom
socket onto bottom hinge pin.
12. Tape Fresh Food door on top right and left
corners.
13. Place center hinge pin and spacer ring(s) on
center hinge bracket. Pin must fit through
bracket and into Fresh Food door socket.
14. Rehang freezer door by positioning bottom
socket onto center hinge pin.
15. Tape freezer door shut on top right and left
corners.
16. Remove plastic plugs from top of refrigerator
cabinet. Insert in opposite side.
17. Place top hinge and spacer(s) on opposite side
of refrigerator cabinet. Insert screws and tighten.
18. Replace top hinge cover by snapping on.
19. Replace bottom hinge cover by snapping on.
20. Replace toe grille by inserting clips in holes and
snapping in. Top of toe grille is indicated on
back of toe grille.
Leveling Refrigerator
1. Remove toe grille by pulling forward.
2. Remove bottom hinge cover by prying cover away
from hinge bracket.
3. Turn leveling screw clockwise to raise refrigerator
or counterclockwise to lower refrigerator.
4. Open and close both doors completely.
Important:
If refrigerator cannot be level due to flooring, use
shims under roller(s) to level refrigerator.
5. Turn leveling screws clockwise equally on both
side until front of refrigerator is 6.4 millimeters
higher than back.
6. Turn stabilizing leg until firmly in place againstfloor.
7. Replace bottom hinge cover by snapping on.
8. Replace toe grille by inserting clips in holes and
snapping in. Top of toe grille is indicated on
of toe grille.
4
back