HoMedics HP-M100-2EU Manual De Instrucciones página 6

HP-M100-2EU-1_IB.qxd:Layout 1
INSTRUCTIONS FOR USE :
• Position Heat and Massage controls to OFF.
• Plug the adapter into a 230 volt AC outlet and plug the receptacle end into the input jack
located along the side of the hand control next to the cord.
• Select Massage and Heat Settings:
a. There are three heat and two massage settings that can be used independently
or together.
b. For heat, turn the dial to the desired level. To turn off, turn the dial back to the
"OFF" position.
c. For massage, slide the "MASSAGE" switch to the desired level. To turn off, slide
the switch back to the "OFF" position.
Important Note: Only one side of the pad will heat up. Refer to the label on the
vinyl heating pad to ensure you have the proper side facing your body.
• Place pad over desired body area. Use the elastic straps to conveniently secure the pad to
your body. Always allow air to circulate freely between the heating pad and the surface of
the skin. When treatment is completed, turn unit off, unplug the power supply and store
properly in a dry place.
Caution: All servicing of this heating pad must be performed by authorised HoMedics
personnel only.
For Moist Heat
• Dampen the absorbent sponge with warm water.
• Gently wring out any excess water.
• Place the sponge on top of the heating pad and slip the cover
over the heating pad. Close snap to secure.
• Plug pad into any 230 volt outlet and set control to the desired
heat setting.
22/5/09 12:43 Page 6
6