Fitting The Batteries - BH FITNESS G2342 Manual De Instrucciones

FITTING THE BATTERIES

This monitor
ALKALINE BATTERIES. To fit the
batteries, carefully insert the two "R-6"
type batteries
compartment (A), figure 1, making
sure that the battery's polarity is
correct (matching the battery's "+"
terminal with the "+" sign inside the
battery compartment, and the "-"
terminal with the "-" sign). Replace the
battery compartment cover.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important. Used batteries must be
discarded in special containers. Figure
2.
FITTING THE ELECTRONIC
MONITOR.
ATTACHING
CABLE. Take hold of cable 53, which
is sticking up out of the main post, and
plug it into the connector 53a at the
back of the electronic unit, as shown
in figure 3 A.
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connectors
54 and 55, sticking out of the main
post, and plug them into 54a and 55a
connectors, located at the back of the
monitor (P), as shown in figure 3 A.
FITTING THE
uses two 1.5
into the battery
THE FEEDBACK
ELECTRONIC
English
MONITOR. Remove screws (C), figure
1, from the base of the monitor, then
slide the front of the monitor onto the
volt
plate on the main post (B), figure 3,
making sure not to snag any of the
wires, fit the screws (C) removed
previously and tighten securely.
ELECTRONIC MONITOR
To give you greater control over the
exercise, this electronic unit gives
simultaneous read-outs of speed and
rpm alternating with distance, exercise
time, calories burnt and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key on
the monitor. The monitor switches on
as soon as you start to exercise on the
machine.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes, with the screen
displaying the temperature.
A. SCAN FUNCTION
This function uses the large screen to
provide a sequential display of all the
values shown in the small windows, to
cancel this function press the MODE
key and the large screen will freeze
the value being displayed at the time
when the MODE key was pressed.
B. TIME FUNCTION
This function counts up or down in
steps of one second, up to a
maximum of 99:00 seconds.
1. Pressing the MODE key will select
the TIME window, the value to be
programmed will start flashing.
2. Pressing the SET key will display
8