Fitting The Batteries - BH FITNESS Tecnovita YC200 Manual

FITTING THE BATTERIES

This monitor
ALKALINE BATTERIES. To fit the
batteries, carefully insert the two "R-6"
type batteries
compartment (A), figure 1, making
sure that the battery's polarity is
correct (matching the battery's "+"
terminal with the "+" sign inside the
battery compartment, and the "-"
terminal with the "-" sign). Replace the
battery compartment cover.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important. Used batteries must be
discarded in special containers. Figure
2.
ELECTRONIC MONITOR
To give you greater control over the
exercise, this electronic unit gives
simultaneous read-outs of speed and
rpm alternating with distance, exercise
time, calories burnt and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key on
the monitor. The monitor switches on
as soon as you start to exercise on the
machine.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes, with the screen
uses two 1.5
into the battery
English
displaying the temperature.
A. SCAN FUNCTION
volt
This function uses the large screen to
provide a sequential display of all the
values shown in the small windows, to
cancel this function press the MODE
key and the large screen will freeze
the value being displayed at the time
when the MODE key was pressed.
B. TIME FUNCTION
This function counts up or down in
steps
maximum of 99:00 seconds.
1. Pressing the
select the TIME window, the value
to
flashing.
2. Press MODE key to confirm.
3. Pressing the MODE key 2 sec the
programmed exercise time will be
reset.
C. DISTANCE FUNCTION
This function counts up or down in
steps of 0.5 km, up to a maximum of
99.9 km.
1. Pressing the MODE key will select
the DISTANCE window, the value
to
flashing.
2. Pressing
the exercise distance.
3. Press MODE key to confirm.
4. Pressing MODE key 2 sec the
programmed exercise distance will
be reset.
D. CALORIE FUNCTION
This function counts up or down in
steps of 10 calories, up to a maximum
of 990 kcal.
7
of one second,
UP/ DOWN keys
be programmed
be programmed
UP/DOWN
up to a
will
will start
will start
will program