Fault Finding Chart; Error Codes - BH FITNESS G-639 Manual De Instrucciones

FAULT FINDING CHART

PROBLEM
1. The monitor
does not switch
on.
2. The monitor
switches on but
the motor fails to
start.
3. Walking motion
is jerky on the
treadmill
4. The machine
stops (the breaker
trips)
5. Electrical
shocks through
the handrail.
6. The treadmill
belt skews
centre

ERROR CODES

Monitor screen displays E1
Monitor screen displays E6-E7
Do not hesitate to get in touch with us if you have any queries, by calling:
CHECKS
1)Make sure that the machine is
plugged in, the ON/OFF switch
in position I and that the safety
key is inserted.
2) Check that the current limiter
is pressed in.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on the
sliding belt.
3.c) Check the tension on the
drive belt.
4) Check that the band is
lubricated
5) Check that the machine is
plugged into an earthed mains
socket.
6.a) Check that the machine is
off level on the floor
6.b) Check that the machine
does not wobble.
- Speed sensor fault.
- Elevation fault
902 170 25
15
SOLUTIONS
1) Plug the machine into
the mains supply.
Set the switch
position I and insert the
safety key.
2)Switch the machine off
and press the circuit
breaker in. Lubricate the
treadmill band.
3.a) Lubricate the sliding
belt.
3.b) Adjust the
tension.
3.c) Adjust the drive belt
tension.
4)Reset the overload
button with the On/Off
switch at "0"
lubricate the treadmill
band.
5) Plug the machine into
an earthed
socket.
6) Use the adjustable
feet to level
machine.
to
belt
and
mains
the