Fault Finding Chart; Error Codes - BH FITNESS G-6446 N Manual De Instrucciones

FAULT FINDING CHART

PROBLEM
1.The monitor does not switch
on.
2.The monitor switches on but
the motor fails to start.
3.Walking motion is jerky on
the treadmill.
4.The machine stops (the
breaker trips).
5.Electrical shocks through
the handrail.
6.The treadmill belt skews off
centre.

ERROR CODES

Monitor screen displays E1
Monitor screen displays E2
Monitor screen displays E4
Do not hesitate to get in touch with us if zou have any queries, by calling:
CHECKS
1) Make sure that the
machine is plugged in, the
ON/OFF switch in position 1
and that the safety key is
inserted.
2) Check that the current
limiter is pressed in.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on the
sliding belt.
3.c) Check the tension on the
drive belt.
4) Check that the band is
lubricated.
5) Check that the machine is
plugged into an earthed
mains socket.
6.a) Check that the machine
is level on the floor.
6.b) Check that the machine
does not wobble.
- Possible motor overload.
- Lubricate the belt.
- Switch the machine off and on again.
- Body fat function fault.
- Restart the machine and place your hands
correctly for a pulse rate reading.
902 170 258
10
SOLUTIONS
1) Plug the machine into the
mains supply. Set the
switch to position 1 and
insert the safety key.
2) Switch the machine off and
press the circuit breaker in.
Lubricate the treadmill
band.
3.a) Lubricate the sliding belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt
tension.
4) Reset the overload button
with the On /Off switch at
„0" and lubricate the
treadmill band.
5) Plug the machine into an
earthed mains socket.