Tabla de contenido
Idiomas disponibles
Idiomas disponibles
021417 IM42XX MOULI
• Set the steam control (
consulting the table below.
F
ABRIC
L
INEN
C
OTTON
WOOL
S
ILK
S
YNTHETIC
(Polyester, Acetat,
Acrylic, Nylon)
= STEAM ZONE
• Your iron heats up quickly : so begin by ironing fabrics that
are ironed at low temperatures first, then go on to those
requiring a higher temperature.
Wait a few seconds
between each shot before
pressing the button again.
Spray Function
• Whether steam or dry ironing, you are able to use the
fig.9
button
(
) to dampen laundry to remove stubborn crea-
ses.
Every fifth time you press
the button, return the iron
to the horizontal position.
The steam is very hot, so
you should always do this
with the garment on a
hanger – never while
someone is wearing it.
Store your iron
• Set the steam control to
• Wait until the soleplate cools down and empty the reservoir. A
little water may remain in the reservoir.
• To wind the cord around the heel of the iron, slot the Easycord
system into the notch (
system and press to make the flexible part go back into the base
fig.12
(
). Wind the cord.
• Store the cold iron on its heel (
4
18/10/06
16:29
Page 4
fig.7
) to the desired position,
P
S
OSITION OF
TEAM SETTING
POSITION
THERMOSTAT CURSOR
MAX
•••
••
•
Obtain more steam
Boost
• Press the
button
fig.8
creases (
).
Vertical steam ironing
Ideal for removing creases in suits, jackets, skirts, curtains, etc.:
• Hang the garment on a hanger and hold the fabric slightly taut
with one hand.
• Set the thermostat control to MAX (
Boost
• Press the
button repeatedly (
from top to bottom (fig
• Hold the iron a few centimetres from the fabric to avoid burning
delicate fabrics.
and unplug the iron.
fig.11
). Take the end of the Easycord
fig.13
).
In order to avoid water
dripping from the iron
onto the linen:
- turn off the steam when
ironing silk or synthetic
fabrics.
- set it at the minimum
position
for wool.
If you turn down the ther-
mostat, wait until the
thermostat light comes
back on before beginning
to iron again. When
ironing fabrics with mixed
fibres, set the ironing
temperature for the most
delicate fibre. For delicate
fabrics we recommend
testing the fabric first on
an inconspicious place eg
(inside the hem).
If you want to dry iron, set
the Steam control to
.
(depending on model)
now and again to remove stubborn
Spray
(depending on model)
fig.5
).
fig.8
) moving the iron
.
10).
Tabla de contenido
