Converting Unit To Power Edger; Connecting To Power Supply; Extension Cord - Stihl FSE 60 Manual De Instrucciones

10 Converting Unit to Power Edger

Squeeze the locking hooks (3) together to
release the depth wheel (1) from the support (2).
9.2 Fitting Depth Wheel on Deflec‐
tor
1
► Push the depth wheel (1) with support on to
the deflector (4).
1
► Secure the depth wheel (1) on the deflec‐
tor's (4) hook (6) with the locking tab (5).
The depth wheel (1) can be released from the
hook (6) and pulled off the deflector (4) by raising
the locking tab (5) slightly.
10 Converting Unit to Power
Edger
2
1
► Loosen the screw (1).
► Rotate the loop handle (2) 180°.
► Tighten down the screw (1) firmly.
0458-282-9821-C
4
4
5
6
5
The trimmer can now be turned through 180°
and used as a power edger (see "Applications").
11 Connecting to Power Sup‐
ply
The voltage and frequency of the machine (see
rating plate) must match the voltage and fre‐
quency of the power connection.
The minimum fuse protection of the power con‐
nection must comply with the specifications – see
"Specifications".
The machine must be connected to the power
supply via an earth-leakage circuit breaker to dis‐
connect the power supply if the differential cur‐
rent to earth exceeds 30 mA.
The power connection must correspond to
IEC 60364 and relevant national regulations.
11.1

Extension cord

The design of the extension cord must at least
fulfill the same features as the connecting cord
on the machine. Observe the design marking
(type designation) on the connecting cord.
The cores in the cord must have the following
minimum cross-section depending on the mains
voltage and cord length.
Cord length
220 V – 240 V:
Up to 20 m
20 m to 50 m
100 V – 127 V:
Up to 10 m
10 m to 30 m
English
Minimum cross-section
2
1.5 mm
2
2.5 mm
2
AWG 14 / 2.0 mm
2
AWG 12 / 3.5 mm
29