Tabla de contenido
15 ENGLISH
AC/DC Adaptor connection
The clock radio unit can be powered by an external AC-DC adaptor, required the output DC 5V
500mA (included)
POWER CONNECTION
Plug the AC/DC adaptor to a household outlet AC source, connect the adaptor's DC output plug
to the DC-in jack of the clock unit. This unit is equipped with a battery back up system, it requires
a 3V CR2032 fl at lithium battery (not included). Insert the battery in the battery compartment,
making certain that the positive and negative (+ and -) battery terminals are attached to the
corresponding terminals on the plate in the battery compartment. If an AC power failure occurs,
the clock automatically switches to the battery power supply, the clock and timer memory continue
running. When the AC power resumes, the clock switches back to AC again.
GETTING STARTED
Press the reset button locates on the back of unit after AC plug in.
-
The unit will display full segment for 2 seconds, then it will enter the normal mode.
Setting Clock Time / Wireless Transmitter Channel
1) With the OFF mode, press and hold the time set / memory button ; "24 Hr" will blink.
2) Press the Tune + or Tune – button to set the unit to the "12 Hr" mode or "24 Hr" mode.
3) Press the time set / memory button and the hours will blink.
4) Press the Tune + or Tune – to set the current hour, then press the time set / memory button
again the minute digits will blink.
5) Press the time set / memory button and the channel 1 will blink.
6) Press the Tune + or Tune – to set the channel 1 / channel 2 / channel 3.
7) When done and you press time set / memory button once again and the display time will blink
to indicate the current time is set.
Setting Alarm Time
When you set the alarm, you choose the light intensity level, the type of sound and the sound
level. The alarm is set when the light ring round the ALARM button burns. The light intensity slowly
increases to the chosen level during the last 20 minutes before the set alarm time.
*** For example, if you set the alarm time on 8:30 am, the light will slowly increase to max level 20
started from 8:10 am. ***
1) To preview the alarm time, press the ALARM button once.
2) While the display is showing the alarm time and hold the ALARM button for 3 seconds and the
hours will blink.
3) Press the Tune + or Tune – to set the alarm hour.
4) Press the ALARM button again; the minute digits will blink. Press the Tune + or Tune – to set
the alarm minutes.
5) Press the ALARM button and you can change the sound mode (Buzzer, Radio, and Nature)
for the alarm.
6) Press the Tune + or Tune – to choose different sound mode.
7) Press the ALARM button again; the volume digits will blink, press the Tune + or Tune – to set
the alarm sound level.
8) Press the Alarm button again; the light digits will blink, press the Tune + or Tune – to set the
alarm light level.
9) Press the ALARM button when done.
Snooze and deactivate alarm
To delay the alarm, press SNOOZE, it will come on again in approx. 9 minutes. You may repeat
this cycle several times during the alarm cycle.
Tabla de contenido
