AneX Quant Manual De Instrucciones página 6

EN
6
PRE-USE PROCEDURES
STROLLER ASSEMBLING/DISASSEMBLING
Remove the stroller frame from the box and place it horizontally on the
floor (Fig. 1). Holding the handle with one hand, pull it up vigorously until
the system locks in (you should hear a distinctive sound) (Fig. 2, 3). To
fold the frame, press the button on the frame and turn the mechanism to
fold the frame in the specified direction (Fig. 4). Then, without releasing
the frame, pull it up (Fig. 5) and bring it to the original position in which
it was after unpacking (Fig. 1).
The frame has two folding positions with the wheels installed: Horizontal
position — to do this, you need to unlock and rotate the front wheels
in the direction of each other so that they are on the same line (Fig. 6);
Vertical position — it is necessary to lock the front wheels. This position
is convenient for storage of the frame in the room (Fig. 7).
Besides, the stroller can be folded together with the seat, provided
that the seat is installed in facing the direction of movement. Here,
the footboard is mounted in the lower position and the hood visor is
wrapped inside (Fig. 8).
HANDLE HEIGHT ADJUSTMENT
Press the button on the handle and set it to a comfortable height, it is necessary
to pull the handle upward (Fig. 9) simultaneously. The handle is adjustable in
4 positions. Last position (lowest) is only for folding the stroller. Do not use it to
operate the stroller.
MOUNTING/DISMOUNTING OF THE REAR WHEELS
To install the rear wheel, it is necessary to insert the wheel axle in a
particular place on the frame and push it until it is fixed (Fig. 10). To
remove the wheel, press the button and drag the wheel along the axis
(Fig. 11).
INSTALLING/REMOVING FRONT WHEELS SWIVEL/LOCK
The frame of the stroller is equipped with two front swivel wheels that
rotate at 360° degrees around vertical axis. To fit the front wheels, the
wheel axle must be installed in the appropriate position on the frame