Nice OVBT Instrucciones Y Advertencias Para La Instalación Y El Uso página 8

- control an automation by sending a text message to Oview via the
Gsm network;
- manage an automation from the "Oview Software Suite", connected
to Oview via a Gsm/Gprs (internet) connection.
If you wish to use the module to send the automation an "Open" com-
mand by means of a phone call made with an authorised telephone,
continue the procedure as follows:
09. Make sure that Oview is connected to a powered-up control unit.
10. Use the and keys to choose the automation you wish to con-
trol by means of a phone call, then select "commands".
11. On the following screen choose "num. Tel GSM" and press
"select";
12. in the screen that now appears, enter the telephone number of
the phone you want to use in the future to send the "Open" com-
mand to the automation. Now select "new" and press "selec-
tion". After entering the number, use the
the option "on" or "off" to enable or disable this number (the num-
ber in any case remains memorised) and finally press "ok" to
memorise the number.
To memorise other desired phone numbers (maximum 255), re-
peat the instructions of point 12.
To modify or delete a number that has already been memorised,
choose the number, press "select" and proceed as described in
point 12.
3.2.2 - Services available with "Gsm/Gprs" connection
• Automation command by phone: this allows you to send the
automation an "Open" command. To send the command, on the au-
thorised phone (the one memorised in point 12 of paragraph 3.2.1)
simply dial the number of the SIM card present in the Oview module
and wait for 3 rings. The telephone call is free of charge.
• Automation command by text message: this enables you to send
the automation 4 different commands: "open", "close", "block", "re-
6 – English
lease" (if the commands are sent using a phone enabled for text mes-
sages), or 5 different commands: "open", "close", "block", "release",
"Gprs" (if the commands are sent using a phone equipped with "Win-
dows Mobile" operating system, "Oview Software Suite" and access
to the mobile phone network).
The text message must be made up of the following elements (impor-
tant! – insert the commas as indicated; the spaces are optional):
Notes:
- Password is the personal password entered during the configuration
procedure (paragraph 3.2.1, point 08); Assembly and Address are
the two values characterising the automation the command is to be
sent to; Command is the actual command that is to be sent to the
automation.
and keys to choose
- The name of the command must be written in the same language
as set in Oview (e.g. "chiude" in Italian; "close" in English, etc.), with
the exception of the "Gprs" command which remains the same in
all languages.
- For use of the "Gprs" command, refer to the procedure "For subse-
quent connection to Oview" in this chapter.
- For security reasons, if a text message reaches Oview 20 minutes or
more after it has been sent, it will be ignored. This means that it is
important to check regularly that the correct time is set on Oview.
• Management of the automation by means of "Oview Software
Suite": if you have a computer with "Windows Mobile" operating sys-
tem and access to the mobile phone network, you can use "Oview
Mobile" to connect to Oview by means of the Gprs network. If instead
you have a computer with "Windows" operating system and access to
a landline phone network, you can use "Oview Desktop" to connect to
Oview via the Internet.
In both cases all the functions present in the software are available with
the exception of the "Firmware update" and "Test update" functions.
, Password , Assembly , Address, Command