DT SWISS R 535 ONE Manual De Instrucciones página 16

3.3 MOUNTING THE SHOCK
1. Install the shock in accordance with the specifications of the bicycle or frame manufacturer.
→ Observe the specifications of the bicycle or frame manufacturer when setting the tightening
torque of the fastening screws.
→ If using shocks with trunnion mount, do not exceed a tightening torque of 20 Nm (see image).
2. Check to ensure the rear shock is installed correctly. To do this, release some air (see Sec. 5.4 on
page 19) and compress the shock completely in the frame.
→ No part of the shock may come into contact with the frame, aside from the connection points.
→ Ensure that all moving parts can move freely.
3. Increase the air pressure to the desired pressure (see Sec. 5.3 on page 19).
16
max.
20 Nm