TEUFELBERGER GRANIT PRO Manual Del Usuario página 12

USE
Pic. 7
1. Pull end of strap to tighten it. (Pic. 7)
2. Pull tongue to loosen it. (Pic 8)
b) SafeClick buckle
Pic. 9
Closing the buckle
Push the parts of the buckle together until you hear
a "CLICK" noise. Check proper locking/functioning
of the buckle (buckle halves freely movable inside
each other, gap between buckle halves 2-3 mm;
pulling at both buckle halves).
Opening the buckle
1. Push buckle halves together.
2. Simultaneously press both unlocking buttons
towards the TEUFELBERGER logo
3. Pull parts of the buckle apart.
3. Fall arrest and holding eyelets:
Fall arrest eyelets - EN 361
Pic. 10 / Granit Pro
Front D-ring consisting of two rings (EN 361) in the
chest (marked with an A)
CAUTION always join both rings (with a carabiner
snap hook).
12
Pic. 8
Pic. 11 / Granit Pro
Side and seat D-Rings (Granit Pro only)
In combination with a fall arrest system according
to EN 353-1, the D-ring (Fig. 14) may also be used
as follows: The carabiner hook of the simultaneously
running arrest system is attached to the two loops
on the sub-pelvic strap; in addition, a connection to
the upper D-ring of the fall arrest harness (marked
"A") should be created (e.g. with a suitable carabi-
ner snap hook according to EN 362 or a connector
according to EN 354)
The Granit Pro model is equipped with brackets for
material on the sub-pelvic straps ("material loops"
- Fig. 15) and tool holders ("attachment rings - Fig.
16).
Pic. 15
They must not be used to belay persons and have
the following max. load carrying capacity (static):
Gear loop (Pic. 15):
25 kg max. per loop (e.g., to transport carabiners,
ascenders, aluminum pulleys)
Tool bag attachment ring (Pic. 16)
10 kg max. per ring
(for attaching one tool bag to 2 rings each)CAUTI-
Pic. 12
Fall arrest eyelet (EN 361)
in the area of the breast
(designated A)
- Granit Pro only
Pic. 13
Holding eyelets (EN 358)
laterally at the waist belt
Pic. 14
Holding eyelet (EN 813)
front center at the waist
belt
Pic. 16