Replacing Components; Main Components - Gastrodomus TEU664P Serie Instalación, Uso, Mantenimiento

THE OVEN CANNOT BE SWITCHED ON
check the multi pole swicth is closed and there is
mains voltage
Check to have correctly set the cooking cycle
parameters.
Ascertain the oven is not in error.
THE APPLIANCE DOES NOT HEAT.
Possible causes:
- The electronic board is damaged
- Heating elements defective.
- Safety thermostat tripped.
HEATING CANNOT BE ADJUSTED.
Possible causes:
- The electronic board is damaged
WATER DOES NOT FLOW INTO THE HUMIDIFIER
TUBES.
Possible causes:
Check that the water shut-off cock is open.
The solenoid valve is damaged
14.

REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, BEFORE CARRYING OUT ANY
OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
VENTILATED OVEN
SOSTITUTION OF THE LAMP
Open the oven door.
Remove the wrap.
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE HEATING ELEMENT
- Open the door.
Remove the wrap.
- Remove and replace the component.
- Refit all parts.
- Following, in reverse order, the sequence used for
their removal.
REPLACEMENT OF THE ELECTRONIC BOARD, THE
SECURITY THERMOSTAT AND THE ENGINE
- Open the door.
- Remove the wrap.
- Remove the inner panel.
- Remove and replace the component.
- Refit all parts.
- Following, in reverse order, the sequence used for
their removal.
15.

MAIN COMPONENTS

- Electronic board
- Heating elements
- Safety thermostat
- engine
21