Function Mode; Remote Control - Cardin Elettronica ZVL120.00 Manual De Instrucciones

Function mode

• Semi-automatic (Dip 1 = OFF, Dip 2 = OFF)
- automatic reclosing deactivated
- each transmitter channel works as a sequential command.
Open - Stop - Close - Stop.
• Semi-automatic (Dip 1 = OFF, Dip 2 = ON)
- automatic reclosing deactivated
- the transmitter channels have the following functions:
A - Open - B - Close - C - Stop - D - Sequential.
• Automatic (Dip 1 = ON, Dip 2 = OFF)
- automatic reclosing enabled
- the transmitter channels have the following functions:
A - Open - B - Close - C - Stop - D - Sequential.
• Manual mode (Dip 1 = ON, Dip 2 = ON)
- manual operation during closing.
- the closing photocell "FTC" intervenes blocking the motor
- the sequential command has no effect
- the transmitter channels have the following functions:
A - Open - B - Close - C - Stop - D - No function.
Note:
- Bridging the "TA" and "TC" contacts will transform "TA" into a sequential command with the func-
tions Open-Stop-Close-Stop.
- The "manual" manoeuvre function can also be obtained by simply keeping the "TA" button (or the
"TC" button) held down for more than one second.
- If a security device is in alarm (stop button, photocell, CSP or CSPF) the LED "L2" will flash quickly.
Emergency manoeuvre
Attention:
The emergency manoeuvre must only be used in situations of extreme necessity and
the movement of the automation must be controlled visually at all times as the safety devices are
excluded. The emergency manoeuvre is only enabled if the jumper J4 is inserted.
If one or more safety devices have cut in and blocked the movement of the shutter you may move the
shutter manually by pressing and holding down the opening button "TA" or the closing button "TC"
for 5 seconds.
The emergency movement may also be activated via radio by the remote opening and closing com-
mands

Remote control

Memorising a channel
1) Press and hold down button "P2": LED "L3" will flash.
2) At the same time activate the transmitter channel to be memorised, "L3" will flash 3 times indicat-
ing that the channel has been memorised; if the LED keeps flashing slowly the channel was already
memorised. Only one channel can be memorised at a time. To insert another channel repeat points
1 and 2 after having released the button. When the code memory is complete (20 transmitters each
with 4 channels memorised) you may only memorise a new transmitter after you have completely
cancelled an existing transmitter (all the buttons) or after cancelling the entire memory content.
Cancelling a channel
1) Press the button "P2" twice and hold down after pressing the second time: LED "L3" will flash at
brief intervals.
2) Activate the transmitter channel to be cancelled until the LED flashes 3 times.
To cancel another channel repeat points 1 and 2 after having released the button.
13