Environmental Protection - Worx WG303E Traducción De Las Instrucciones Originales

MAINTENANCE
Before any work on the machine itself,
pull the mains plug from the socket.
Note: To ensure long and reliable service,
carry out the following maintenance regularly.
Regularly check for obvious defects such as
loose, dislodged or damaged chain and guide
bar, loose fixings and worn or damaged
components.
Check that covers and guards are undamaged
and correctly fitted. Carry out necessary
maintenance or repairs before using the chain
saw.
If the chain saw should happen to fail despite
the care taken in manufacturing and testing,
repair should be carried out by an authorized
customer service agent.
If the replacement of the supply cord is
necessary, this has to be done by the
manufacturer or his agent in order to
avoid a safety hazard.
Before returning, ensure all oil in the oil
tank has been emptied.
Replacing/Changing Chain and guide bar
Fit the chain and guide bar as described in
"Assembly and Tensioning Chain" .
The circular groove of the guide bar will wear
particularly on the lower edge with time.
When replacing the chain turn the chain bar
180° to allow even wear, thus extending chain
bar life.
Check drive sprocket. If it is worn out or
damaged due to strain, have it exchanged by
an authorized service agent.
If the chain bar is worn out or damaged,
take the chain tensioning catch off the bar
by loosing the screw anti-clockwise. Then
fit the tensioning catch into the new bar by
tightening the screw clockwise. The catch
protrude (a) must be fitted into the bar hole.
(See Fig M)
Sharpening chain
Have your chain sharpened professionally
at your approved service agent or sharpen
the chain yourself using the sharpening kit.
Follow the sharpening instructions supplied
with the sharpening kit.
Chain saw
CLEANING/STORAGE
Clean the moulded plastic housing of the
chain saw using a soft brush and clean
cloth. Do not use water, solvents or polishes.
Remove all debris, especially
from the motor cooling vents.
Remove and brush clean the cover plate,
chain and chain bar after 1 to 3 hours of use.
Clean the area under the cover plate, the drive
sprocket and chain bar assembly using a soft
brush. Clean oil outlet with a clean cloth.
If the chain saw is to be stored for a longer
period of time, clean chain and chain bar.
Store in a secure, dry place out of the reach of
children.
Do not place other objects on the chain saw.
To prevent leakage ensure machine is left in a
horizontal position (oil filler cap 4 uppermost).
When storing machine in original packaging
the oil tank must be completely emptied.
ENVIRONMENTAL
PROTECTION
Recycle unwanted materials instead of
disposing of them as waste. All tools and
packaging should be sorted, taken to the
local recycling centre and disposed of in an
environmentally safe way.
17
EN