Installation Steps - LUND AVS Ventvisor Instrucciones De Instalación

Installation Steps

Buff the inside of window channel with Scotch-
Brite scuff pad. Then clean the channel with an
1
Insert visor into window channel, rear flange first.
3
NOTE: It is necessary to both hold the visor up into the
window channel AND pull the bottom of the visor slightly
outward while raising the glass to seat visor properly.
5
Raise window slowly and leave up for 72 hours to
secure visor to window channel.
7
NOTE: Actual application may vary slightly from illustrations.
alcohol pad.
Remove tape liner from front & rear flanges. Peel back
2" of tape liner from each end of top flange.
top flange
2
Remove remaining tape liner.
4
Continue to apply pressure to ensure that the visor
remains properly seated inside the window channel
as window is slowly closed. Leave window up for 72
hours to secure visor to window channel.
72
50°F / 10°C Min.
6
If the visor does not seat correctly, roll down
Page 2 of 3
free end
front
flange
window and repeat Step 5.
rear
flange