Installation Steps - LUND BELMOR Chop Top Instrucciones De Instalación

Installation Steps

outside of
vehicle
2
Peel back 2" (5 cm) of red tape liner from each flange
of driver side visor.
free end
3
Cross section view of visor flange and tape in proper
outside of vehicle
tape
visor
5
With the visor in its final position, remove remaining
tape liner by pulling on free ends.
7
NOTE: Actual application may vary slightly from illustrations.
Apply one coat of Surface Prep to the prep surface area as indicated.
prep
surface
free end
position.
window
channel
Slide the front end flange into position inside the gutter.
Then rotate visor up and slide the lateral and rear end
4
Verify proper positioning, and press the exposed areas
of tape against the inside metal surface.
window
channel
6
Firmly run your finger along the inside of the tape
flange to ensure proper adhesion of the taped flange to
8
Page 2 of 3
flanges into proper position.
the metal surface.