Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation Steps
Note: For fog light or tow hook equipped trucks, cut out the back of the fog light cavity and
trim for proper light and/or tow hook operation.
Place two strips of the double sided tape on the inside of the panels as shown.
Installed tape should contact the top edge of the chrome portion of the bumper,
Note: Greater strength can be achieved with professional grade automotive body
1
adhesive.
#10 x 1/2 self tapping screws
Thoroughly wash the front bumper and dry. Using the Alcohol pad provided wipe the
middle bumper to remove any dirt or oil.
Attach passenger's and driver's front panels to the vehicle bumper as shown. Press the
panels firmly into place.
2
46014
Rev. -
1" x 5" Strip
Tape
Bumper
Page 2 of 4
Secure side pieces using two #10 x 1/2" screws through the upper portion of the formed
flange to the inside the wheel well.
3
1/4" hex bolt
Attach the front air dam to the front bumper using (2) 1/4"-20 x 1" hex head bolts, (2)
1/4" Wrought washers and (2) 1/4"-20 Nylock nuts through the front plate holes in the
4
front bumper as shown. If so equipped, license tag screws and inserts can be used.
46014
Rev. -
Bumper
#10 x 1/2 self tapping screws
Bumper
Page 3 of 4
Tabla de contenido
