Puma Go Manual De Usuario página 21

Timer setting mode:
Press and hold S4 until Hour starts blinking from Timer mode to
Timer setting mode. Press S1 to advance the setting, Press and Hold
S1 for fast setting. Press S2 to set the next digit. The sequence in
Timer setting mode is Hour—Minute—cD-S/cD-r/cD-U.
S3/S4
S4
3 Sek.
Stunde
drücken
Press S4 or S3 to exit the setting mode. If there is no operation for 2
to 3 minutes, the watch will return to Timer mode automatically.
Alarm mode:
Press S3 shortly from Timer mode to Alarm mode. There are 2 daily
alarms which are working independently. It is presented by Alarm
number, Hours, Minutes, and Alarm status.
Press S2 in Alarm mode to select AL-1 to AL-2
Weckermodus Weckzeit 1
2-3 Sek.
40
S3/S4 S3/S4
Minute CD-S/CD-U/CD-R
S2 S2
S2
Weckzeit 2
S2
S2
Press S1 in Alarm mode to arm or disarm the alarm or chime of the
selected alarm. Below is the sequence of display after pressing S1.
Wecker EIN u. Wecker AUS u.
Weckton EIN Weckton AUS
S1
The alarm sounds daily for 20 seconds at alarm time when the
alarm is set to oN. Press any key to stop the alarm sound. If any
alarm is active, alarm mark is also on. If chime is oN, there is an
hourly chime. Pressing any button will have a beep sound whether
the chime is oN or off.
Alarm Setting mode:
Press and hold S4 in alarm mode to enter alarm setting mode.
The hour digit starts flashing at 1 hertz. The alarm is turn "oN"
automatically. Press S1 to advance the setting by 1. Press and hold
S1 for fast setting. Press S2 to set the next digit. The sequence for
setting is Hour—Minute—T1/T2.
Wecker EIN u.
Stunden
Weckton EIN
S4 3 Sek.
drücken
S3/S4
Press S3/S4 to exit setting mode. If there is no key operation for 2 to
3 minutes, watch will exit setting mode automatically.
Water Resistance:
This watch is water resistant up to 5 ATM.
Weckton AUS Wecker AUS
Wecker EIN Weckton EIN
S1 S1
S1
Minuten T1/T2
S2 S2
S3/S4 S3/S4
S2
41