Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PROGRAMMING
®
NOTICE: If this Security✚
the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the copyright in the
garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will
open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
USING THE LIGHTED DOOR CONTROL
1. Remove the cover from the Lighted Door
Control.
2. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
3. While holding the remote button, press
and hold the "A" button on the Lighted
Door Control.
4. Continue holding both buttons while you
press the "B" button on the Lighted
Door Control (all three buttons are held).
5. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of
To Add or Reprogram a Hand-held Remote Control
"B"
Button
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
"A"
Button
Press and hold the "learn" button on
motor unit until the learn indicator light
goes out (approximately 6 seconds). All
previous codes are now erased.
Reprogram each remote or keyless entry
you wish to use.
*Multi-Function Remotes (315 MHz)
If provided with your garage door opener, the large button
is factory programmed to operate it. Additional buttons on any
®
Security✚
multi-function
remote or mini-remote can be
programmed to operate other
®
Security✚
garage door
openers.
"A"
Button
"B"
Button
36
®
315 MHz remote controls.
Capítulos
Tabla de contenido
