General Power Tool Safety Warnings; Work Area Safety - Parkside PFBS 12 B2 Traducción Del Manual De Instrucciones Original

SMPS – switched-mode
power supply
Charging time:
Safety transformer,
short-circuit-proof
Protection class:
Polarity:
Protection type
Max. Ambient temperature:
Noise emission value:
Noise measurement value determined in accord-
ance with EN 60745. The A-rated noise level of
the power tool is typically as follows:
Sound pressure level:
Uncertainty:
Sound power level:
Uncertainty K:
Wear hearing protection!
Total vibration value:
a = 1,216 m/s 2
h, SG
Uncertainty K: 1.5 m/s
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons. The
specified vibration emission value can also
be used to make an initial exposure estimate.
PFBS 12 B2
approx. 3 hours
II / (double insulation)
IP20
Protection against solid
objects with a diameter of
more than 12.5 mm
ta: 40°C
L = 61.8 dB (A)
pA
K = 3 dB
pA
L = 72.8 dB (A)
WA
K = 3 dB
WA
2
WARNING!
► The vibration level varies depending on the
use of the power tool and may be higher
than the value specified in these instructions
in some cases. Regular use of the power tool
in this way may cause the user to underesti-
mate the vibration. Try to keep the vibration
loads as low as possible. Measures to reduce
the vibration load are, e.g. wearing gloves
and limiting the working time. Wherein all
states of operation must be included (e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
General power tool
safety warnings
WARNING!
► Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result
in electric shock, fire and/or serious
injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
GB │ IE │
19 ■