Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5 5 . . 3 3 . . 2 2 D D e e f f i i n n e e f f i i r r s s t t S S c c a a l l i i n n g g p p o o i i n n t t
Firstly set the input value for the start of
the slope using the respective unit (mA, V)
Than set the display value for the start of
the slope
5 5 . . 3 3 . . 3 3 D D e e f f i i n n e e t t h h e e s s e e c c o o n n d d s s c c a a l l i i n n g g p p o o i i n n t t
Set i i n n p p u u t t v v a a l l u u e e
Set d d i i s s p p l l a a y y v v a a l l u u e e
5 5 . . 3 3 . . 4 4 D D e e f f i i n n e e f f u u r r t t h h e e r r s s c c a a l l i i n n g g p p o o i i n n t t s s
Additional scaling points will be requested
only, when in section 5.3.1 more than 2
5 5 . . 4 4 T T o o t t a a l l i i z z e e r r
The totalizer accumulates the input display
(instantaneous) values with a sampling
rate of 1 per second.
If the measurement signal is out of range
or
by the display alternating between
and
and
.
www.kuebler.com
, this is indicated
or
Menu <–> Selection
press the
key to accept
Menu <–> Selection
press the
key to accept
Menu <–> Selection
press the
key to accept
Menu <–> Selection
press the
key to accept
scaling points are defined.
The totalier continues adding the meas-
urement results. If the measurement signal
is out of range, over-range
under range
and
or
. appears in the display and the
totalizer stops.
Example: –5.000
Select digit
Set digit
Example: –250.0
Select digit
Set digit
Example: 2.000
Example: 300.0
or
, than
and
Page 15
Tabla de contenido
