Kübler CODIX 555 Manual Del Usuario página 60

5 5 . . 1 1 1 1 C C h h e e c c k k / / A A l l t t e e r r P P a a r r a a m m e e t t e e r r s s
Menu <–> Selection
6 6 O O p p e e r r a a t t i i o o n n
The unit is in the operating mode, when
the power supply is switched on or at the
end of the set-up.
326.81 The measuring signal has
been applied and lies within the
limits of the measuring range. The
display will show either the current
The input value is below the lower
limit of the measuring range. This
message alternates with the
˜ The input value is higher than the
upper limit of the measuring range.
This message alternates with the
The input value is less than -13.6 V.
Current inputs below 0.0 mA are not
measured.
The input value is higher than 11.0 V
or above 21.5 mA
Page 28
Checking the individual menu items
• after every 2 seconds the menu changes
to Selection
• If the setting is as desired, then switch to the next menu
with key, otherwise, start the set-up again.
One of the following will be displayed dur-
ing operation.
measured value, the totalizer value,
the MAX value or the MIN value.
current measured value or with the
value of the totalizer.
current measured value or with the
value of the totalizer.
www.kuebler.com