2. Prepare the Wall
1"
(25 mm)
58"
(1473 mm)
To Floor
CAUTION: Risk of property damage. Do not drill into cables or pipes behind
the wall.
NOTE: If possible, install the product on a flat and even wall surface, avoiding any
grout lines.
NOTE: The recommended height above the floor is 58" (1473 mm).
Mark the center of the interface installation location.
Use a level and a pencil to mark the mounting hole locations, 1" (25 mm) to each
side of the center hole.
Drill a 1-1/4" (32 mm) hole at the center mark.
Drill a 3/16" (5 mm) hole at the mounting hole locations.
Install anchors into the mounting holes.
Feed the interface cable from the digital valve through the center hole.
Kohler Co.
Ø 1-1/4"
(32 mm)
5
1396161-2-C