Speed Programming Simple Heating Processes - Renfert Magma Instrucciones De Uso Originales

3. Speed Programming
Simple Heating
Processes
The speed programme is indicated by the programme
number „P_ _".
The speed programme includes only the increase
and holding phases for stage 4.
During the increase phase, heating always occurs at
the maximum rate (not programmable).
1. Press the "P" key,
2. Select the speed programme
The speed programme, „P_ _", is located
between P99 and P01.
You can also switch to the speed pro-
gramme if you press the upper + OR - key
from the normal display.
3. Adjust the holding temperature
4. Adjust the holding time (h:min), max. 3 hr.
5. Program the casting time (if desired)
- Briefly press the timer key:
- Current casting time displayed
Date
Time
- Set a new casting time is desired (in 15-minute
increments):
6. Press the Start / Stop key – start the speed pro-
gramme
- The casting time is displayed (for approx.
2 sec.):
Date
Time
- Increase phase:
Current oven temperature
- Display in the holding phase:
Current oven temperature
Remaining holding time (h:min)
Other possible displays are described in Sec. 5.3.1.
7. The speed programme ends at the conclusion of
the 4th stage holding time. This is indicated by an
acoustic signal.
The following actions can be performed once the
speed programme has run out:
• NONE:
The acoustic signal automatically switches off after
approx. 15 sec. and the temperature is maintained.
• Open and close the oven door:
The acoustic signal switches off, die and the tem-
perature is maintained.
or
• The acoustic signal switches off, and the tempera-
ture is maintained.
or
The acoustic signal switches off, the oven switches
to the post-heating mode (refer to Sec. 5.5).
:
The acoustic signal switches off, the heater switch-
es off and the programme terminates.
- 5 -
:
(upper +/- keys):
EN