Technical Parameters - YATO YT-82234 Manual Del Usuario

CHARACTERISTICS OF TOOL
Orbital sander is an ordinary tool, of the class II isolation, designed mainly for fi nishing of wood and to a lesser extent for sanding
metal surfaces, especially in the corners and places diffi cult to access. Grinding is done with a paper, which is commonly availa-
ble in trade, or with an abrasive cloth, in the form of properly shaped surfaces. In any case, you should not use the tools for the
machining of materials other than those listed above, for example. for grinding plaster, fi llers with fi ber reinforcement, etc. Correct,
reliable, and safe operation of the device is dependent on its proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
Attention! The dust generated during grinding of certain surfaces can be harmful for health, and even toxic.
This note applies to i.a. grinding the surfaces coated with paints containing lead, to some species of wood, some metals (e.g.
lead) and materials, therefore, during the work you should use an eff ective dust extraction, dust masks and other measures to
protect the skin and respiratory tract. For any damage caused by failure to comply with safety regulations and instructions of this
manual, the supplier is not responsible.
EQUIPMENT
The sander is supplied complete, with one sheet of sandpaper and connector for dust discharge..

TECHNICAL PARAMETERS

Parameter
Type
Mains voltage
Mains frequency
Rated power
Number of oscillations
Dimensions of the foot
Dimensions of the abrasive sheet
Weight
Noise level
- accustic pressure LpA ± KpA
- accustic power LwA ± KwA
Vibrations a ± K
h
Insulation class
Degree of protection
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
Do not expose power tools to contact with atmospheric precipitation or moisture. Water and moisture that gets inside the
power tool increases the risk of electric shock.
Do not overload the power cable. Do not use the power cord to carry, pull or unplug the power plug from the power outlet.
10
O R I G I N A L
GB
Unit
[V]
[Hz]
[W]
[min ]
-1
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s ]
2
I N S T R U C T I O N S
Value
YT-82234
230
50
300
10 000
229 x 115
275 x 115
2,75
75,0 ± 3,0
86,0 ± 3,0
4,83 ± 1,5
II
IP20