Important Notes on
Operation
Use and storage
Do not subject the unit to severe shocks
The internal mechanism may be damaged or the body
warped.
Do not cover the unit while operating
Doing so will cause temperatures to rise inside the unit,
possibly resulting in failure.
After use
Turn off the on/standby button.
If you plan not to use the unit for a long time, turn off the
main power switch on the rear panel as well.
Shipping
• Always power the unit off.
• If sending the unit by truck, ship, air or other
transportation service, pack it in the shipping carton of
the unit.
• If the unit is shipped without being properly packed and
protected. Its Internal parts may be damaged.
Referring to the Installation Manual, be sure to mount
the screws and fittings to ensure safe transportation.
• If the unit is transported with the drive unit not removed,
the unit and the drive unit may be damaged during
transportation. Be sure to remove the drive unit from this
unit before proceeding to transportation.
Care of the unit
If the body of the unit is dirty, clean it with a soft, dry cloth.
In extreme cases, use a cloth steeped in a little neutral
detergent, then wipe dry. Do not use organic solvents such
as alcohol or thinners, as these may cause discoloration or
other damage to the finish of the unit.
In the event of operating problems
If you should experience problems with the unit, contact
your Sony service or sales representative.
Use and storage locations
Store in a level, ventilated place. Avoid using or storing the
unit in the following places.
• In excessive heat or cold (operating temperature range:
5 °C to 35 °C (41 °F to 95 °F))
Remember that in summer or in warm climates the
temperature inside a car with the windows closed can
easily exceed 50 °C (122 °F).
• In damp or dusty locations
• Locations where the unit may be exposed to rain
• Locations subject to violent vibration
• Near strong magnetic fields
• Close to radio or TV transmitters producing strong
electromagnetic fields.
• In direct sunlight or close to heaters for extended periods
To prevent electromagnetic interference from
portable communications devices
The use of portable telephones and other communications
devices near this unit can result in malfunctions.
It is recommended that the portable communications
devices near this unit be powered off.
Condensation
If the unit is suddenly taken from a cold to a warm location,
or if ambient temperature suddenly rises, moisture may
form on the outer surface of the unit and/or inside of the
unit. This is known as condensation. If condensation
occurs, turn off the unit and wait until the condensation
clears before operating the unit. Operating the unit while
condensation is present may damage the unit.
Parts Replacement
The carrier (transport mechanism) is a consumable part
that will need periodic replacement.
When operating at room temperature, a normal
replacement cycle will be about every five years.
However, this replacement cycle represents only a general
guideline and does not imply that the life expectancy of
these parts is guaranteed. For details on parts replacement,
contact your dealer.
LCD
Over a long period of use, because of the physical
characteristics of the liquid crystal display, "stuck" pixels
may appear spontaneously. These problems are not a
malfunction.
Precautions for Drive Units
Snocks and vibrations
Do not subject the drive unit to shocks when a cartridge is
inserted.
Transporting the drive unit
Before transporting the drive unit, be sure to eject the
cartridge.
55
Important Notes on Operation