General Setup - Plantronics CT10 Manual De Usuario

Ocultar thumbs Ver también para CT10:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

CT10MultiLangInside.R1
7/3/00
STEP 1

GENERAL SETUP

SELECTING A LOCATION
Install the CT10 Base Unit
in a location that is near an AC power outlet
19
and a modular telephone line jack. The base's location effects the
telephone's range. Try several locations to see which provides the best
performance. Select a location that is away from electrical machinery,
electrical appliances, metal walls, filing cabinets, wireless security alarms,
room monitors, and areas of excessive moisture.
GETTING STARTED
Unpack the unit and check for the following items:
CT10 Remote
3
Rechargeable Battery
18
CT10 Base
19
AC Adapter
28
Telephone Line Cord
30
Headset
1
CONNECTING THE TELEPHONE BASE
Place the Base
on its back exposing the AC Adapter Jack
19
Telephone Jack
on its underside.
31
Plug the AC Adapter Plug
into the AC Adapter Jack
27
Adapter
into an AC power outlet. The Power Indicator
28
after being connected. The In-Use Indicator
Connect one end of the Telephone Line Cord
Jack
and the other end into a Telephone Wall Jack
31
Press both the Telephone Line Cord and the AC Adapter Cord into the
Cord Retainer Clip
.
32
2:21 PM
Page 6
G
G
and
26
A
. Plug the AC
26
G
will light
21
will remain off.
22
into the Base's Telephone
30
A
.
29
6
STEP 1
SETUP THE REMOTE
PREPARING THE REMOTE FOR USE
Remove the paper separator between the Remote
Rechargeable Battery
by pulling it out.
18
Note: If the paper rips before coming out. The Remote and the
Rechargeable Battery Pack can be separated by sliding the Remote up
and the Battery Pack down. They can be reassembled by reversing this
action.
Plug the Headset into the Headset Jack
on the Remote
6
the Cable into the Headset Cable Retainer
.
9
CHARGE THE REMOTE
Firmly slide the Remote
into the Remote Charging Well
3
Battery Charge Indicator Light
flashes.
23
The Battery Charge Indicator Light will go off
when the battery is fully charged.
(It's important to make good contact in the
charging well to properly charge the battery.)
The Remote may be operated while in its Charging Well after gaining
5 seconds of orientation. The Charge Indicator Light will stop flickering
when orientation is attained.
Once charged, the Remote can be operated away from the Base.
7
and the
3
B
C
and snap
3
D
until the
24
E
G
E
Tabla de contenido
loading

Tabla de contenido