Bosch 0 607 350 198 Manual Del Usuario página 22

OBJ_BUCH-1326-001.book Page 22 Monday, October 11, 2010 10:32 AM
22 | English
Exhaust Line (see figure B)
With an exhaust line, exhaust air can be con-
ducted through an exhaust hose away from your
workplace and, at the same time, optimal muf-
fling/silencing can be achieved. Additionally,
your working conditions are improved, as your
workplace is freed from oil-contaminated air or
stirred up dust or chips.
Unscrew the muffler 2 at the air outlet and re-
place it with the hose nipple 18 with male thread.
Loosen the hose clamp 13 of the exhaust hose
19 and attach the exhaust hose over the hose
nipple 18 with male thread by firmly tightening
the hose clamp.
Changing the Tool
Disconnect the air hose from the air source
before making any adjustments, changing
accessories, or storing the air tool. Such
preventive safety measures reduce the risk of
starting the air tool accidentally.
The rated speed of the accessory must be at
least equal to the maximum speed marked
on the air tool. Accessories running faster
than their rated speed can burst and fly apart.
Use only flawless tool bits that are not
worn. Defective tool bits can break, for ex-
ample, and cause injury or damage.
Selecting the Sanding Sheet
Depending on the material to be worked and the required rate of material removal, different sanding
sheets are available:
Sanding disc Material
– Paint
– Varnish
– Filling compound
– Filler
White quality
3 609 929 C02 | (11.10.10)
Replacing the Sanding Sheet
When attaching a new sanding sheet, remove
any dust or debris from the sanding plate 9, e.g.,
with a brush.
The surface of the sanding plate 9 is fitted with
Velcro backing for quick and easy fastening of
sanding sheets with Velcro adhesion.
Press the sanding sheet 10 firmly against the
bottom side of the sanding plate 9.
Type 0 607 350 199|... 200
– Pay attention that the holes in the sanding
sheet are positioned directly above the holes
in the sanding plate; this ensures optimal
dust extraction.
Application
For sanding paint off
For sanding primer (e.g., for removing
brush dashes, drops of paint and paint
run)
For final sanding of primers before
coating
Grain size
coarse 40
60
medium 80
100
120
fine 180
240
320
Bosch Power Tools