MTD EB 1000 Manual De Instrucciones página 9

EB 1000
6. T
ROUBLESHOOTING
P
ROBLEM
n
Motor will not start
n
Cutting head will not turn
when throttle is squeezed
n
Cutting head will not
advance line
7. S
PECIFICATIONS
M O T O R
Motor ................................................................................................................................... Electric
Operating RPM ...................................................................................................... 7500 - 8500 g/m
Ignition Switch ......................................................................................................... Control switch
Drive shaft ........................................................................................................................... 6,2 mm
Cutting head .......................................................................................... "Bump Head" reel feeding
Vibration Level ................................................................................................................. 3,65 m/s
Sound pressure level (no load) ...................................................................... LPAm = 74,8 dB (A)
Measured sound power level (no load) ........................................................... LWA = 94,8 dB (A)
Guaranteed sound power level (no load) ........................................................... LWA = 96 dB (A)
Cutting path diameter .......................................................................................................... 400 mm
Operating weight .................................................................................................................. 5,5 Kg
Trimming line diameter .......................................................................................................... 2,0 mm
All information, illustrations and specifications in this manual are based on the latest product
information available at the time of printing, We reserve the right to make changes at any time
without notice.
4
C
AUSE
1. Motor stops / will not
start
2. Cutting head bound with
grass or debris
1. Flex shaft broken
2. Flex shaft not engaged
1. Cutting head out of line
2. Inner reel bound up
3. Cutting head dirty
4. Indexing teeth worn or
burred
5. Line welded
6. Line twisted when re-
filled
7. Nut enough line is
exposed
A
CTION
1. Check curd to see if it is
plugged into an electrical
outlet
2. Stop motor and clean
cutting head
1. Contact service dealer
2. Contact service dealer
1. Refill with new cutting
line
2. Replace inner reel
3. Clean inner reel and
outer spool
4. Replace inner reel and
outer spool
5. Disassemble, remove
the welded section and
rewind the line
6. Disassemble and rewind
reel
7. Push the Bump Knob
and pull out 102 mm of
line until the line is
outside of the cutting
head
2