Idiomas disponibles
Idiomas disponibles
1. Turn the water tap on.
2. Press the ON/OFF button: the indicator light will
illuminate.
3. Open the door and pour in a suitable amount of
detergent ( see below ).
4. Load the racks ( see Loading the racks ) and shut
the door.
5. Select the desired wash cycle depending on the
dishes and how dirty they are ( see table of wash
cycles ), by turning the knob clockwise.
6. Select the wash options (see below).
7. Start the cycle by pressing the START/RESET
button: the machine will emit a confirmation beep.
The WASH CYCLE PHASE indicator lights display
the status of the cycle:
Pre-wash, Wash, Rinse, or Drying.
8. At the end of the cycle three short beeps will
sound and the DRYING indicator light will flash.
9. Switch off the appliance by pressing the ON/OFF
button, shut off the water tap and unplug the
appliance from the electricity socket.
10. Open the door and wait for a few minutes before
removing the crockery, in order to avoid burns.
Unload the racks, beginning with the lower level.
If a mistake was made during the wash cycle
selection process it is possible to change the cycle,
provided that it has only just begun: press and hold
the START/RESET button for 4 seconds. After one
long beep and three short beeps, the WASH CYCLE
PHASE indicator light will switch off: select the new
cycle and switch the machine back on by pressing
the START/RESET button.
Press the ON/OFF button and open the door, taking
care to avoid the escaping steam, and place the
crockery inside the dishwasher. Press the ON/OFF
button again: the cycle starts from the point at which
it was interrupted.
If the door is opened during the wash cycle, or if
there is a power cut, the cycle stops. It starts again
from the point at which it was interrupted once the
door has been shut or the electricity supply is
restored.
A successful wash also depends on the correct
amount of detergent being used, as recommended
by the manufacturer. Exceeding the recommended
amount does not result in a more effective wash and
pollutes the environment.
To obtain the best results from each washing and
drying cycle, powder detergent, rinse aid liquid and
salt should be used.
compar
compar
tment A
tment A
compartment A
compar
compar
tment A: Washing detergent
tment A
compar
compartment B
compar
compar
compar
tment B
tment B
tment B: Pre-wash detergent
tment B
D
A
B
C
requires 1 tablet, place it in compartment A and
close the cover; when it requires 2, place the second
tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
To make sure that the crockery is completely dry at
the end of the cycle, press the EXTRA DRYING
button before selecting the wash cycle. A prolonged
beep will sound to indicate that this option has been
selected and a short beep will sound to indicate
when it has been deselected.
If the Extra drying option is selected, the wash
cycles will last longer.
* Only available in selected models.
1. Open cover C by
pressing button D.
2. Pour in the detergent
after consulting the Wash
cycle table :
• for powder detergent
use compartments A and
B
• for tablets, use
compartment A and the
bottom of the appliance,
i.e. when the cycle
