General Instructions - T&S B-0126 Instrucciones De Instalación Y Mantenimiento

General Instructions

Installation:
See separate instructions for installa-
tion of no.1 into deck.
1. Shut off water supply and drain
lines. Apply teflon tape or pipe joint
compound to threads on both ends of
no.2.
2. Screw no.2 into no.1 and tighten by
hand.
wall
3. Screw no.6 onto no.2. Apply teflon
tape or pipe joint compound to bottom
end of no.4. Screw no.4 into no.6.
4. For maximum security and efficiency,
install two no.3.
Note: For models
using no.5, attach
no.5 with no.7 in
7
5
3
4
5. Apply a small amount of teflon tape
or pipe thread compound to end of
no.9. Screw no.9 into no.8 at top of
no.4, making sure ring at the end of
no.9 is positioned as shown below.
4
6
2
6. Attach no.13 to no.5 (if used) or
no.7, make sure no.15 is in place.
1
7. Install no.10 to no.9 by removing
pin at top of no.10, and attach to ring
of no.9 and replace pin.
8. Assemble no.11 and no.12 to fit
onto no.13, so that the no.14 hangs
in a convenient place. (Approximately
14" to 18 ½" from work surface.)
9. Turn on water and check for leaks.
Note: Optional Wall Bracket
The no.3 should be installed after
place.
entire unit is assembled. Fit bracket
on no.2 and no.4 as high as possible.
Cut off any excess nipple
(unthreaded end) as needed, and
mount to wall.
ring
8
10
9
7
5
11,12
15
13