Temperature Settings; Temperature Calibration - Thermo Fisher Scientific Elite CTS Manual Del Usuario

TDS Factor Setting
1. Press to enter setup window. Scroll down by pressing
2. Press to select settings. The display shows TDS factor and Backlight.
3. Press to select the default TDS factory setting or
4. Press to confirm the selection of the setting. The display shows the set TDS factor with a
Key Info
Scroll
Accept
EXIT
Backlight Settings
1. Press to enter setup window. Scroll down by pressing
2. Press to select Settings. The display shows TDS Factor and Backlight.
3. Scroll down by pressing
4. The display shows ON and OFF. Scroll down by pressing
increases readability in low light conditions.
5. Press to select the desired backlight option. The display shows the selected backlight option with a
Key Info
Scroll
Accept
EXIT

Temperature Settings

1. Press to enter setup window. Scroll down by pressing
Temp set. The display shows Set °C/°F, Temp Cal and Temp Coeff.
2. Press to select Set °C/°F. Scroll down by pressing
3. Press to select tempareture unit. The display shows the selected temperature setting with a
Key Info
Scroll
Accept
EXIT

Temperature Calibration

1. Press to enter setup window. Scroll down by pressing
2. Press to select Temp Set. The display shows Set °C/°F, Temp Cal and Temp Coeff.
3. Scroll down by pressing
Temp Cal.
4. The lower display shows the current measured temperature reading based on the last set offset and the upper
display shows the current measured temperature reading based on factory default calibration.
Elite CTS Tester Operating Instructions
Measure
TDS Factor
Settings
Backlight
Temp Set
Reset
to toggle between TDS Factor and Backlight. Press
Measure
TDS Factor
Settings
Temp Set
Backlight
Reset
Measure
Set °C/°F
Settings
Temp Cal
Temp Set
Reset
Temp Coeff
to toggle between Set °C/°F, Temp Cal and Temp Coeff. Press
to select Settings.
to adjust the setting.
Adjust
0.66
TDS Factor
0.71
to select Settings.
to toggle between ON and OFF. Backlight ON
Backlight
OFF
ON
OFF
to select Temp Set. Press
to toggle between °C and °F.
°C
°C
°F
to select Temp Set.
.
to select Backlight.
to select
.
to select
.
3