Replacing The Batteries; Getting Started - Thermo Fisher Scientific Elite CTS Manual Del Usuario

This instruction manual is applicable for Elite CTS Tester.

Replacing the Batteries

The Elite CTS tester uses four AAA 1.5 V batteries.
1. To remove the battery cover, See Figure 1. Clear the front catch and then the back
catch, before sliding the cover off.
2. To remove the battery plate, push the center tab towards the front of the tester as
show in Figure 2. Once unlocked, remove the plate to access the batteries.
3. Invert the tester upside down to remove the batteries. Each side uses two
AAA batteries. Orient each battery with positive terminal facing downward.
4. To lock the battery plate, align the small taps into the guide ribs
on the housing and then press down. See Figure 4.
Figure 2: Push to unlock
Battery Plate Unlock position
Figure 5: Battery plate unlock
Battery Plate Unlock position
position
To Insert battery plate,
align the small taps into
To Insert battery plate,

Getting Started

the guide ribs on the
align the small taps into
housing
the guide ribs on the
housing
The Elite CTS tester has been factory calibrated and usually works well out of the box. However, after extended
periods of non-use, it is best to remove the sensor cap and soak the sensor in warm tap water for 10 minutes or so.
Prior to taking the measurements, periodic callibaration with certified standards is recommended for best accuracy.
Measurement Parameter Setting
1. Press to power on the tester.
2. Press to enter setup window. Press
3. Scroll down by pressing
4. The display shows the selected measure with a
Key Info
Scroll
Accept
EXIT
2
Battery Plate Unlock position
To Insert battery plate,
align the small taps into
the guide ribs on the
To Insert battery plate,
housing
align the small taps into
the guide ribs on the
housing
Figure 3: Align tabs
Battery Plate locking position
To lock the battery plate,
press down and slide in
To lock the battery plate,
press down and slide in
to select Measure. The display shows Cond, TDS and Salinity.
to toggle between Cond, TDS and Salinity. Press
Measure
Cond
Settings
TDS
Temp Set
Salinity
Reset
Battery Plate Unlock position
Battery Plate locking position
To lock the battery plate,
press down and slide in
To lock the battery plate,
press down and slide in
Figure 4: Push down to unlock
Figure 6: Battery plate lock
Battery Plate locking position
position
To Release the battery plate,
Push away this tap.
To Release the battery plate,
Push away this tap.
.
Cond
Battery Plate locking position
Figure 1: Removing battery
cover
To Release the battery plate,
Push away this tap.
To Release the battery plate,
Push away this tap.
to select Cond.
Elite CTS Tester Operating Instructions