Axis M7016 Manual Del Usuario página 9

Note
75 Ohm video termination can be enabled/disabled for the video input through the
product's web page at Video > Camera Settings > Video termination. This termination
is enabled on factory default. In cases where the product is to be connected in parallel
with other equipment, for optimum video quality, it is recommended that termination be
enabled for only the last device in the video signal chain.
Network Connector
RJ45 Ethernet connector.
NO TICE NO NO TICE TICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic Compatibility (EMC) on
page 2 .
RS485/RS422 Connector
Two terminal blocks for RS485/RS422 serial interface used to control auxiliary equipment such
as PTZ devices.
SD Card Slot
A microSD card (not included) can be used for local recording with removable storage. For more
information, see Specifications on page 10.
NO NO TICE NO TICE TICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To
unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Control Button
The control button is used for:
• Resetting the product to factory default settings. See page 12.
• Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic DNS
Service. For more information about these services, see the User Manual.
AXIS M7016 Video Encoder
9