Axis M7016 Manual Del Usuario página 12

AXIS M7016 Video Encoder
Connect the cables
1. Connect the video encoder to the network using a network cable RJ45.
2. Connect the cameras to the video inputs.
3. Connect the supplied indoor power adapter.
4. Check that the indicator LEDs indicate the correct conditions. See LED Indicators on
page 8
NO NO TICE NO TICE TICE
Make sure the unit is properly grounded by using the grounding screw.
If the unit will be used with cameras or accessories located outdoors then its ground screw
should be connected to a local grounding point.
Access the Product
Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup/
Reset to Factory Default Settings
Important
Reset to factory default should be used with caution. A reset to factory default will reset
all settings, including the IP address, to the factory default values.
Note
The installation and management software tools are available on the CD supplied with the
product and from the support pages on www.axis.com/techsup
To reset the product to the factory default settings:
Note
To reset a single channel to the original factory default settings, use the button provided in
that unit's web interface.
It is also possible to reset parameters to factory default via the web interface. Go to Setup
> System Options > Maintenance.
Further Information
The User Manual is available at www.axis.com
12