1605A000DGAB 02-21 7350_7300-PGT 6/2/21 9:21 AM Page 26
Fig. 5
Fig. 6
Instead, lower the spinning accessory lightly to the work and
allow it to touch the point at which you want cutting (or sanding
or etching, etc.) to begin. Concentrate on guiding the tool over
the work using very little pressure from your hand. Allow the
accessory to do the work.
Usually, it is best to make a series of passes with the tool rather
than attempt to do all the work in one pass. To make a cut, for
example, pass the tool back and forth over the work, much as you
would a small paint brush. Cut a little material on each pass until
you reach the desired depth. For most work, the gentle touch is
best. With it, you have the best control, are less likely to make
errors, and will get the most effi cient work out of the accessory.
Questions or Problems? Call 1-800-437-3635
or check our website at www.Dremel.com
26